Full ticket list

If a driver is performing swerving for entry to the road, at the entrance of which crosswalk is located, he/she shall carry out swerving:

1. 1 At high speed only, in order to pass above section of the road in due time
2. 2 At low speed only, in case of necessity to stop and give the way to the pedestrians entered or entering the crossing
3. 3 At any speed, as he/she takes priority over the pedestrians entered or entering the crossing

If traffic of the vehicles on the road with crosswalk is regulated by a traffic controller, on traffic restriction signal the drivers must stop:

1. 1 In front of the traffic controller
2. 2 On reverse traffic lane
3. 3 In front of crosswalk or lateral marking posted before it

If traffic of the vehicles is regulated by neither traffic lights nor traffic controller, on approaching the crosswalk the driver shall:

1. 1 Reduce the speed appropriately, in order not to endanger the pedestrians entered or entering this crossing and in case of necessirty to stop and give way to the pedestrians
2. 2 Give honk and pass the crosswalk without having stopped
3. 3 Has the right to pass the crosswalk at any speed as the one having the priority over the pedestrians

The drivers, intending to drive around the route vehicle at the properly marked stop from the appropriate side of the traffic direction, shall:

1. 1 Increase the speed, in order to pass quickly and not to impede the process of the passenger pick up and drop off by the public transport
2. 2 Stop at the sideway and not to move until proceeding of the public transport
3. 3 Decrease speed and in case of necessity stop, in order to provide chance of safe pick up or drop off the passengers by the public transport

Prior to entering crosswalk, a driver shall make sure that:

1. 1 Not to become obliged to stop on it
2. 2 There is no incoming vehicle on the crossing
3. 3 The crossing surface is not covered with ice

Priority means:

1. 1 The right of a traffic participant, to be the first to drive towards intended direction compared with other traffic participants
2. 2 A traffic participant is obliged not to perform maneuvering, if this forces other traffic participants to change speed and direction suddenly

“Insufficient visibility” means reduction of visibility on the road during passing the tunnel, in dark hours, fog, rain and snow and other natural events:

1. 1 At a distance less than 500 meters
2. 2 At a distance less than 300 meters
3. 3 At a distance less than 600 meters

“Lane line” means:

1. 1 Part of the road, used for motion of the vehicles without rails
2. 2 Any line marked or unmarked by the linear road marking from those linear lines, which may be the driveway
3. 3 Constructively separated element of the road, dividing adjacent driveways and not designated for motion of the vehicles without rails

“Overtaking” means:

1. 1 Faster motion of the vehicle in the concurrent traffic lanes than the vehicles moving in the lines adjacent to the edges of driveway
2. 2 Overtaking one or several preceding vehicles driving in the same direction in the same lane, by leaving the taken lane
3. 3 Driving round one or several oncoming vehicles in neigbour traffic lane

“Stopping” means:

1. 1 Deliberate termination of motion of the vehicle because of orders of technical devices organizing traffic or the traffic controller
2. 2 Deliberate termination of motion of the vehicle in vehicle current
3. 3 Deliberate termination of motion of the vehicle for 5 minutes or more, if this is necessary for passenger pick up and drop off or loading-unloading of the vehicles

Besides the driveways, which of the following elements may be included in the road?

1. 1 Sideways and lane lines only
2. 2 Tram rails and pavements only
3. 3 Both tram rails and pavements, sideways, lane lines and bicycle lanes
4. 4 Bicycle lanes only

„Intersection“ is:

1. 1 Crossing of the driveways existing on various levels
2. 2 Crossing, junction or branching of the roads on one level, including the territories formed after such crossing, junction or branching
3. 3 Entries from adjacent territories and crossings of the road

In case of pelvis and thigh-bone fracture of a person injured after an accident, until arrival of ambulance:

1. 1 Lay him/her on uninjured side, put cold spreading on injured site and give some analgesic drugs
2. 2 Lay him/her in supine position, put tightly rolled spreading or some clothes under his/her knees and give some analgesic drugs

„Inhabited area“ means:

1. 1 Any territory inhabited with people
2. 2 Built-up territory, entry and exits of which are marked with appropriate traffic signs
3. 3 Any road designated for heavy traffic of pedestrians

“Loaded mass” means:

1. 1 Mass of the vehicle defined by the blank production plant without driver, passengers and cargo
2. 2 Actual mass of the vehicle loaded during the given period of time including driver and passengers
3. 3 Mass of the vehicle, without passengers and cargo, but with entire fuel supply and necessary tool set

“Unloaded mass” means:

1. 1 Actual mass of the vehicle unloaded during the given period of time including driver and passengers
2. 2 Mass of the vehicle defined by the registration service, without driver, passengers and cargo
3. 3 Mass of the vehicle defined by the blank production plant without driver, passengers and cargo, but with entire fuel supply and necessary tool set

“Parking” means:

1. 1 Deliberate termination of motion of the vehicle for 5 minutes or more, if this is not related to passenger pick up and drop off or loading-unloading of the vehicles
2. 2 Deliberate termination of motion of the vehicle for 5 minutes or more, if this is necessary for passenger pick up and drop off or loading-unloading of the vehicles

„Dark hours“ mean:

1. 1 Time interval from dawn until twilight
2. 2 Time interval from twilight until dawn
3. 3 Time interval from 6 p.m. until 12 a.m

„Forced stop“ means:

1. 1 Deliberate termination of motion of the vehicle in vehicle current because of orders of technical devices organizing traffic or the traffic controller
2. 2 Termination of motion of the vehicle because of its technical failure, state of cargo, driver (passenger) or sudden obstructions on the road

“Constructive speed” is:

1. 1 Maximum speed of the vehicle defined by the blank production plant
2. 2 Maximum allowable speed limit of the vehicle on this section of the road
3. 3 Speed indicated on the identification sign attached to the vehicle - “Speed restriction”