Full ticket list

At the time of routing on turning, sweep and stowage of road train may be caused by:

1. 1 Hard swerving of steering wheel only
2. 2 Hard braking only
3. 3 Excess speed only
4. 4 Excess speed, as well as hard swerving of steering wheel and hard braking

At the time of routing on the ascent, on the slippery ice-covered road, sweep and stowage of road train may be caused by:

1. 1 Hard swerving of steering wheel only
2. 2 Hard braking only
3. 3 Both hard swerving of steering wheel and hard braking

Which of the braking method is more effective while routing on the steep downhill with the vehicle with mechanical gear box?

1. 1 Periodic hard braking with switched-off hitch
2. 2 Engine braking
3. 3 Periodic slow braking with switched-on hitch and gear box

Upon braking the vehicle with mechanical gear box on steep downhill with engine, a driver shall take into account when selecting transmission, that:

1. 1 Selection of tranmission is not depended upon steepness of downhill
2. 2 Steeper the downhill, higher the transmission
3. 3 Steeper the downhill, lower the transmission

While driving through heavy traffic, chance of traffic accident will be less if vehicle speed:

1. 1 Is noticeably more than speed of other vehicles
2. 2 Is equal to the speed
3. 3 Is noticeably less than speed of other vehicles

In case of slipping of rear axle of the vehicle with rear driving axis during routing in turning, a driver shall:

1. 1 Slightly reduce fuel supply and turn the steering wheel to the slip side
2. 2 Slightly increase fuel supply and not to change the steering wheel state
3. 3 Apply the break and turn the steering wheel to the slip side

In case of heavy snow cover on driveway, while routing on the ground road, a vehicle driver must move:

1. 1 According to the state of the road surface, by changing gear and speed
2. 2 With previously selected low gears and at speed without abrupt turning and stopping

When routing in turning, dynamic corridor of road train and articulated bus exceeds dynamic corridor of single car:

1. 1 By 50-70%
2. 2 By 10-40%
3. 3 By 5%

In case of starting motion on the ascent, in which moment is lowering of park brake lever reasonable?

1. 1 After starting motion
2. 2 Simultaneously with starting of motion
3. 3 Prior to starting motion

A driver of the route vehicle must take into account while routing at this stop in winter conditions, that:

1. 1 Because of high intensity of traffic, driveway surface is dry
2. 2 Ice-covered section is formed after multiple braking
3. 3 Driveway surface does not change due to winter conditions

In case of overtaking by road train and articulated bus, safe side interval to the vehicle to be overtaken shoud not be:

1. 1 Less than 1 meter
2. 2 Less than 1.5 meters
3. 3 Less than 2 meters

When stopping the vehicle in extreme situation, a driver must reduce braking distance:

1. 1 Through single hard braking until full blocking of wheels
2. 2 Through multiple hard influence over brake pedal at the blocking limit of wheels

In case of speeding up of the vehicle while turning, importance of centrifugal force:

1. 1 Is increasing
2. 2 Is decreasing
3. 3 Is not changing

During dark hours or low visibility conditions, while approaching the end of the uphill, a driver must switch the high beams off and switch low beams on:

1. 1 In any case, when approaching the end of the uphill
2. 2 Only upon appearance of oncoming vehicle

During speeding up of the vehicle, tyre traction:

1. 1 Is not changed
2. 2 Is increased
3. 3 Is decreased

If a vehicle driver suddenly meets short ice-covered section of the road while routing on flat road, he/she should:

1. 1 Proceed with the same trajectory without changing the speed
2. 2 Slow down through one-time hard braking
3. 3 Slow down through multiple slow braking

In case the brake shoes get wet after going though the water obstacle, the vehicle driver in order to restore the efficiency of the brakes is required to:

1. 1 Proceed and dry brake blocks through short multiple pedaling
2. 2 Proceed with caution, until the service station
3. 3 Proceed with partly elevated hand brake lever

According to the technical requirements of the vehicles twin wheels are supposed to be installed so that the condition of the ventilation holes of the disks ensure:

1. 1 The possibility to measure only the pressure
2. 2 The possibility to inflate the tires only
3. 3 The possibility both to inflate the tires and measure their pressure

According to the technical requirements of the vehicles it is compulsory to be in working conditions:

1. 1 Only lorry platform side locks
2. 2 Only tank filling lock
3. 3 All of the equipment listed in given test
4. 4 Only door operating gear and locks

Working condition obligation of which equipment of the buses is not considered by technical requirements of the vehicles?

1. 1 Working condition of all of the equipment listed in given test is compulsory
2. 2 Only salon interior light switches
3. 3 Only emergency exits and their actuation equipment