გასწრება და შემხვედრის გვერდის ავლა

Except for entry to the road from the left side, the driver who makes sure that the driver moving behind him/her is going to overtake, is obliged to:

1. 1 Approach the right edge of the driveway and increase the speed
2. 2 Approach the right edge of the driveway as far as possible and not to increase the speed
3. 3 Take the extreme left edge of the same direction and decrease the speed

Is a driver of the vehicle to be overtaken prohibited from interfering in overtaking through increase of speed or other actions?

1. 1 Yes
2. 2 No

“Overtaking” means:

1. 1 Driving round one or several oncoming vehicles in neigbour traffic lane
2. 2 Faster motion of the vehicle in the concurrent traffic lanes than the vehicles moving in the lines adjacent to the edges of driveway
3. 3 Overtaking one or several preceding vehicles driving in the same direction in the same lane, by leaving the taken lane

Using audible and light signals during proceeding towards other traffic participants:

1. 1 Does not entitle priority to the driver over operative vehicles only
2. 2 Entitles priority to the driver
3. 3 Does not entitle priority to the driver
4. 4 Entitles priority to the driver over those specific traffic participants, towards which these audible and light signals are used

A driver may use honk:

1. 1 Only outside of inhabited areas, when warning of other vehicle drivers on intended overtaking is necessary
2. 2 For timely warning only, to avoid traffic accident
3. 3 In any case listed in given test

If during overtaking there appears an obstruction of hazard, of which a driver could not be aware before starting to overtake, the driver shall be obliged:

1. 1 To stop overtaking
2. 2 To give honk and go on overtaking maneuver
3. 3 To increase speed, in order to finish maneuvering in due time

What does the kinematic mode of rotating tool call?

1. 1 Rotating tool circuit speed square ratio with machine's working speed
2. 2 Machine's movement speed ratio with rotating tool circular velocity
3. 3 Machine's movement speed square ration with rotating tool circular speed
4. 4 Rotating tool circular velocity ratio with the speed of the machine's movement

What type is the seeding machine of grain crops?

1. 1 Disc-shaped
2. 2 Winged
3. 3 Rell-to-rell
4. 4 Plate

What kind of seeding machine does for seeder of maize, sunflower, soy, haricot and other digging cultures use?

1. 1 Reel
2. 2 Plate
3. 3 Disc-shaped
4. 4 Winged

What is the principle of seed planting in pneumatic seeder?

1. 1 By the use of number of rotation of sower wheel
2. 2 By the use of vacuum
3. 3 By the use of transverse shearing force

What is the care-growing technology of agricultural crops?

1. 1 Dig out of holes
2. 2 Stones collection and flatten the ground surface
3. 3 Cutting of hills and terracing
4. 4 Scattering of fertilizer, plough, harrow, pre-sowing flatten, sowing, cultivation, harvesting

What purpose does the mowing machine have?

1. 1 Nature grasses and crops mowing
2. 2 Hay or straw reap from heaps, pressing and package of pressed weight
3. 3 Dried and newly mowed grass collection in stripes and heaps

What is the basic driven element of mowing machine?

1. 1 Finger bar
2. 2 Cutting against plate
3. 3 Frame
4. 4 Sharp apparatus