გარე სანათი ხელსაწყოები და ხმოვანი სიგნალი

Switching of low beams and rear sidelights is mandatory in order to mark the vehicle moving on the road during a daytime:

1. 1 Only upon conveyance of group of children by bus or in arranged body of lorry
2. 2 Only upon towing of mechanical vehicle, on the towing vehicle
3. 3 In all cases listed in given test
4. 4 Only on the route vehicles on the lanes specially designated for them, when moving opposite to main flow

If a driver of oncoming vehicle does not indicate its necessity, high beams should be switched off and low beams should be switched on instead of them when passing the oncoming vehicle, before such vehicle at a distance not less than:

1. 1 300 meters
2. 2 150 meters
3. 3 200 meters

High beams should be switched off and low beams should be switched on instead:

1. 1 In order to avoid blurring of vision of other traffic participants or the users of navigational or railway routes along the road
2. 2 If visibility is less than 300 meters
3. 3 When routing in built-up area

If road in inhabited area is sufficiently lighted:

1. 1 Low beams must be switched on
2. 2 High beams must be switched on
3. 3 Sidelights must be switched on

Switching the reverse lights on is allowed:

1. 1 Only in case, when a vehicle is braking
2. 2 In all the above-mentioned cases
3. 3 Only in case, when a vehicle is performing or intending to reverse

Is equipment of the vehicle with front red lights and rear white lights allowed?

1. 1 Yes, special service vehicles only
2. 2 No
3. 3 Yes

Is it permitted to change the construction of the vehicle or equip it with additional lights?

1. 1 Is allowed, only under observation of the orders stipulated by the legislation
2. 2 Is not allowed

Is fixing of lights of various colors of same purpose and directed in the same direction on one and the same vehicle allowed?

1. 1 No
2. 2 Yes
3. 3 Ye, on the operative vehicle only

In inhabited area use of projector and searchlights is allowed to:

1. 1 Motor car drivers carrying dangerous goods only
2. 2 Any driver, at his/her own discretion
3. 3 Drivers of operative and special service vehicles only when performing official duty

Use of projector and searchlight is allowed:

1. 1 In uninhabited area only, if there is no oncoming vehicle
2. 2 In inhabited area, on the driveway of one-way road
3. 3 In inhabited area on the road, where there is only one lane in each direction, without tram rails in the middle

Vehicles may stop or park on the car park without switching any external illuminating device on:

1. 1 Only beyond the driveway and the sideways with hard surface
2. 2 Only on the road illuminated in such a way, where seeing of the vehicle is possible in quite a long distance
3. 3 In any case listed in given test

Parking lights may be switched on instead of front and rear sidelights in inhabited areas, provided that:

1. 1 Length of the vehicle does not exceed 6 meters and width – 2 meters
2. 2 All of the conditions listed in given test is considered
3. 3 The vehicle does not have a trailer

During dark hours or low visibility conditions, while approaching the end of the uphill, a driver must switch the high beams off and switch low beams on:

1. 1 In any case, when approaching the end of the uphill
2. 2 Only upon appearance of oncoming vehicle

During dark hours, in the conditions of heavy snow, which of the external illuminating devices provides better visibility of road?

1. 1 Fog-lights together with low beams
2. 2 Fog-lights together with high beams
3. 3 High beams

What operation does the ploughshare perform?

1. 1 Based on the traces of the wall and retains the sustainability of the plough
2. 2 Cuts the belt in movement parallel plane
3. 3 Cuts the belt in horizontal plane
4. 4 Cuts the belt in vertical plane

What operation does the cutter perform?

1. 1 Based on the trace of the wall and retains sustainability of the plough
2. 2 Cuts the belt in horizontal plane
3. 3 Regulates the plough depth
4. 4 Cuts the belt in vertical plane

General purpose plows are intended for:

1. 1 Trench plough
2. 2 Plowing of ground for growing annual cultures
3. 3 For plowing of peat and marsh grounds

For plowing of peat and marsh grounds.

1. 1 Rotary plough
2. 2 Turning plough
3. 3 For plowing of peat and marsh grounds
4. 4 Trench plough

By what indicators will be selected rational traffic rule of the plough mechanism?

1. 1 Productivity, quality of work performed, simplicity of aggregate service
2. 2 Productivity, meshing width, movement speed of aggregate
3. 3 Quality of work performed, movement speed of aggregate, simplicity of aggregate service
4. 4 Meshing width, movement speed of aggregate, quality of work performed