Full ticket list

A vehicle is more stable against overturn, if its center of gravity is located:

1. 1 Up
2. 2 Down

Which of the braking method is more effective while routing on the steep downhill with the vehicle with mechanical gear box?

1. 1 Engine braking
2. 2 Periodic slow braking with switched-on hitch and gear box
3. 3 Periodic hard braking with switched-off hitch

Upon braking the vehicle with mechanical gear box on steep downhill with engine, a driver shall take into account when selecting transmission, that:

1. 1 Steeper the downhill, lower the transmission
2. 2 Steeper the downhill, higher the transmission
3. 3 Selection of tranmission is not depended upon steepness of downhill

While driving through heavy traffic, chance of traffic accident will be less if vehicle speed:

1. 1 Is noticeably more than speed of other vehicles
2. 2 Is noticeably less than speed of other vehicles
3. 3 Is equal to the speed

In case of slipping of rear axle of the vehicle with front driving axis during routing in turning, a driver shall:

1. 1 Apply the break and turn the steering wheel to the slip side
2. 2 Reduce fuel supply and not to change the steering wheel state
3. 3 Slightly increase fuel supply and adjust the motion direction with the steering wheel

In case of slipping of rear axle of the vehicle with rear driving axis during routing in turning, a driver shall:

1. 1 Slightly reduce fuel supply and turn the steering wheel to the slip side
2. 2 Apply the break and turn the steering wheel to the slip side
3. 3 Slightly increase fuel supply and not to change the steering wheel state

In case of heavy snow cover on driveway, while routing on the ground road, a vehicle driver must move:

1. 1 With previously selected low gears and at speed without abrupt turning and stopping
2. 2 According to the state of the road surface, by changing gear and speed

In case of starting motion on the ascent, in which moment is lowering of park brake lever reasonable?

1. 1 Prior to starting motion
2. 2 Simultaneously with starting of motion
3. 3 After starting motion

When stopping the vehicle in extreme situation, a driver must reduce braking distance:

1. 1 Through multiple hard influence over brake pedal at the blocking limit of wheels
2. 2 Through single hard braking until full blocking of wheels

In case of speeding up of the vehicle while turning, importance of centrifugal force:

1. 1 Is decreasing
2. 2 Is not changing
3. 3 Is increasing

During dark hours or low visibility conditions, while approaching the end of the uphill, a driver must switch the high beams off and switch low beams on:

1. 1 Only upon appearance of oncoming vehicle
2. 2 In any case, when approaching the end of the uphill

During speeding up of the vehicle, tyre traction:

1. 1 Is decreased
2. 2 Is not changed
3. 3 Is increased

If a vehicle driver suddenly meets short ice-covered section of the road while routing on flat road, he/she should:

1. 1 Proceed with the same trajectory without changing the speed
2. 2 Slow down through multiple slow braking
3. 3 Slow down through one-time hard braking

In case the brake shoes get wet after going though the water obstacle, the vehicle driver in order to restore the efficiency of the brakes is required to:

1. 1 Proceed with partly elevated hand brake lever
2. 2 Proceed with caution, until the service station
3. 3 Proceed and dry brake blocks through short multiple pedaling

During dark hours or in low visibility conditions, a driver is obliged to select speed of the vehicle so that stopping distance would be:

1. 1 More than visibility area
2. 2 Less than visibility area

During dark hours, in the conditions of heavy snow, which of the external illuminating devices provides better visibility of road?

1. 1 High beams
2. 2 Fog-lights together with high beams
3. 3 Fog-lights together with low beams

In order to stop slipping caused by braking, a vehicle driver must:

1. 1 Stop braking
2. 2 Switch the hitch off
3. 3 Go on braking without changing of pedaling

Which drawing shows correct arrangement of hands on the steering wheel?

1. 1 I
2. 2 II
3. 3 III

Difference of the radii from the centre of turning to front wheels routing opposite to turning centre and rear wheels routing towards the turning is called:

1. 1 Turning radius of car
2. 2 Allowable corridor of car
3. 3 Dynamic corridor of car

If herd of cattle is crossing the driveway in front of the vehicle, a driver shall take into account, that:

1. 1 No animal may come on the driveway after crossing of the herd
2. 2 Single animals, left behind the herd, may come on the driveway again after crossing of the herd